Skoda Fabia

Since 2000 of release



Shkoda Fabija
# 1.1. The car description
# 2. The engine
# 3. Greasing system
# 4. The power supply system
- 5. Cooling system
   5.1. Check of tightness of system of cooling
   5.2. Check of a stopper of a broad tank
   5.3. Removal and radiator installation on models without the conditioner
   5.4. Removal and radiator installation on models with the conditioner
   5.5. Removal and installation of the water pump on models with petrol engines
   5.6. Removal and installation of the water pump on models with diesel engines
   5.7. Removal and installation of the fan of a radiator
   5.8. Replacement of the gauge of inclusion of the fan
   5.9. Removal and thermostat installation
   5.10. Thermostat check
   5.11. Replacement of hoses of system of cooling of the engine
   5.12. Check of level of a cooling liquid
   5.13. Replacement of a cooling liquid
# 6. System of release of the fulfilled gases
# 7. Transmission and a running gear
# 8. A steering
# 9. Brake system
# 10. An electric equipment
# 11. A body
# 12. Electroschemes




5.1. Check of tightness of system of cooling
THE GENERAL DATA

Radiator of system of cooling

1 – a radiator;
2 – a sealing ring;
3 – a bringing hose of a radiator;
4 – a cover of a broad tank;
5 – connecting колодка;
6 – a hairpin;
7 – a fan casing;
8 – the screw;
9 – a broad tank;
10 – the additional fan;
11 – a fan arm;
12 – the holder of wires;
13 – the fan;
14 – an arm;
15 – a taking away hose of a radiator;
16 – the gauge of inclusion of the fan;
17 – the bottom support of a radiator;
18 – a bolt;
19 – the top support of a radiator

PERFORMANCE ORDER
1. Start up the engine and warm up it to working temperature.
2. Uncover 4 (fig. the Radiator of system of cooling see) broad tank 9.

The prevention

On the heated-up engine the system is under pressure, therefore cover a stopper with a rag and remove its outstretched arm.


3. Establish on a mouth of a broad tank 1 tester 2 representing the manual piston pump with a manometre.
4. Raise the pump of a tester 2 pressure in system of cooling to 0,1 мПа and wait 10 minutes
5. If superfluous pressure in system decreases during specified time, means, system негерметична. Find places of leaks of a cooling liquid and eliminate a leak.