| 1. Remove the storage battery and an arm of its fastening. |
| 2. Disconnect both cables 3 and 4 from levers on a transmission. For this purpose, using a wrench 1 as the lever and having enclosed under it flat-nose pliers 2 as a support, remove tips of cables from spherical fingers of 5 levers. |
| 3. Turn away three bolts 1 (fig. of Fastening of an arm of cables of a drive of a transmission of type 002 see) fastenings of an arm of 2 cables to a transmission. |
| 4. Remove a cover of the lever of a gear change (subsection 7.1.2.4 see). |
| 5. Accurately having hooked a screw-driver, remove facing 5 (fig. of the Detail of fastening of a cover of the lever of a gear change see) floor console. |
| 6. Turn on two nuts of 1 forward fastening of the case of the mechanism of 2 gear changes (subsection 7.1.2.5 see). |
| 7. Turn away eight nuts 6 (the Connecting plug of a reception pipe of the muffler fig. see models with a type transmission 02T) fastenings and remove a cross-beam 7. |
| 8. Take out from the holder 5 wire of the oxygen gauge (ljambda-probe). |
| 9. Turn away two screws of fastening and remove a protective casing 10 колодки a ljambda-probe. |
| 10. Having weakened an inhaling of coupling bolts of 3 collars of fastening of the connecting plug 2, disconnect a reception pipe 1 from the resonator of 4 systems of release of the fulfilled gases. |
| 11. Disconnect the resonator from a pillow of 8 fastenings of a suspension bracket. |
| 12. Disconnect a reception pipe 17 (fig. System of release of the fulfilled gases of the engine of 1,0 l, 37 kw and 1,4 l, 50 kw see) from pillows 8. |
| 13. Remove теплоизоляционный the screen 9 (the Connecting plug of a reception pipe of the muffler fig. see models with a type transmission 02T). |
| 14. Turn away a bolt 16 (fig. of the Detail of the mechanism of a gear change) fastenings of the case 14 mechanisms of a gear change see and remove a drive of a gear change from the car. |
| 15. Replace the damaged or strongly pressed out sealing lining 11. The lining 11 executed with a glutinous layer, is pasted on the case of the mechanism of a gear change. |
| 16. Establish a gear change drive upside-down. Before connection of cables to levers grease with a thin layer консистентной greasings of the plug 2 (subsection 7.1.2.5 see) tips, without supposing greasing hit on tip consolidation. After installation adjust a gear change drive. |