Skoda Fabia

Since 2000 of release



Shkoda Fabija
# 1.1. The car description
# 2. The engine
# 3. Greasing system
# 4. The power supply system
# 5. Cooling system
# 6. System of release of the fulfilled gases
- 7. Transmission and a running gear
   # 7.1. A transmission
   - 7.2. A forward suspension bracket
      7.2.1. Removal and installation of a telescopic rack
      7.2.2. Repair of a telescopic rack
      7.2.3. Replacement of a spherical support
      7.2.4. Removal and installation of the lever of a forward suspension bracket
      7.2.5. Removal and installation of an arm of a forward suspension bracket
      7.2.6. Replacement резинометаллической support
      7.2.7. Removal and installation of the stabilizer of cross-section stability
   # 7.3. A back suspension bracket
# 8. A steering
# 9. Brake system
# 10. An electric equipment
# 11. A body
# 12. Electroschemes




7.2.7. Removal and installation of the stabilizer of cross-section stability
PERFORMANCE ORDER
1. Remove грязезащитный a guard картера the engine.
2. Turn away two bolts 3 (fig. in subsection 7.1.2 see) fastenings of a back support 2 power units to a transmission.
3. Turn on from both parties of a suspension bracket on two bolts 2 (fig. Fastening of a holder of a pillow of the stabilizer see) fastenings of holders of pillows of a bar of the stabilizer. The bottom bolt on the right side can be taken only after the beam of a forward suspension bracket will be lowered.
4. Turn on from both parties of a suspension bracket on one nut 1 (fig. rack Fastening to a bar of the stabilizer of cross-section stability) fastenings see and disconnect racks 3 from a bar 2 stabilizers.
5. Turn away bolts 1 (fig. Fastening of the steering mechanism to a beam of a forward suspension bracket see) fastenings of the steering mechanism to a beam 2 forward suspension brackets.
6. Fix the steering mechanism by means of a wire.
7. Lower a beam approximately on 40 mm (subsection 7.2.5 see).
8. Remove both holders of pillows of a bar of the stabilizer.
9. Having turned the bent ends of a bar of the stabilizer upwards, deduce a bar towards a back part of the car.
10. Replace the pillows of a bar of the stabilizer torn or lost elasticity.
11. Establish a stabilizer bar into place. Carving connections of a suspension bracket definitively tighten on the car standing on the earth.