Skoda Fabia

Since 2000 of release



Shkoda Fabija
# 1.1. The car description
# 2. The engine
# 3. Greasing system
# 4. The power supply system
# 5. Cooling system
# 6. System of release of the fulfilled gases
# 7. Transmission and a running gear
# 8. A steering
# 9. Brake system
- 10. An electric equipment
   10.1. Removal and installation of the block of safety locks
   10.2. The storage battery
   # 10.3. Ignition system
   10.4. Removal and installation of a combination of devices
   # 10.5. A cleaner and a windscreen washer
   - 10.6. A cleaner and a washer of glass of a door of a back
      10.6.1. Adjustment of position of levers with screen wiper brushes
      10.6.2. Removal and installation of a motor-reducer of a screen wiper
      10.6.3. Replacement of jets of a washer
   10.7. Replacement of lamps
   10.8. Removal and headlight installation
   10.9. Removal and installation of a back lantern
   10.10. Replacement of an additional lantern of a signal of braking
   10.11. Switches and switches
   10.12. Removal and installation of sound signals
   10.13. Removal and installation динамиков
   10.14. Removal and aerial installation
# 11. A body
# 12. Electroschemes




10.6.2. Removal and installation of a motor-reducer of a screen wiper
THE GENERAL DATA

Details of a cleaner of glass of a door of a back

1 – the lever;
2 – a brush;
3 – a washer jet;
4 – a sealing ring;
5 – a motor-reducer;
6 – a nut of fastening of a motor-reducer;
7 – a pillow;
8 – распорная the plug;
9 – a sealant;
10 – a nut;
11 – a decorative cap

Removal of a motor-reducer of a door of a back

1 – connecting колодка;

2 – a washer hose;

3 – a nut;

4 – a motor-reducer

PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Lift a decorative cap 11 (fig. of the Detail of a cleaner of glass of a door of a back see) on the lever of 1 screen wiper.
3. Turn on not to the end (not to damage a platen carving) a nut of 10 fastenings of the lever of a screen wiper.
4. By means of flat-nose pliers pull off the lever 1 from a cone of the platen of a screen wiper.
5. Definitively turn away a nut of 10 fastenings and remove the lever 1 from the platen.
6. Remove the bottom upholstery of a door of a back.
7. Disconnect колодку 1 (fig. Removal of a motor-reducer of a door of a back see) with wires from a motor-reducer 4.
8. Disconnect a hose 2 from the motor-reducer union.
9. Turn away three nuts of 3 fastenings and remove a motor-reducer 4.
10. Establish a motor-reducer upside-down.