Shkoda Fabija
# 1.1. The car description
# 2. The engine
# 3. Greasing system
# 4. The power supply system
# 5. Cooling system
# 6. System of release of the fulfilled gases
# 7. Transmission and a running gear
# 8. A steering
# 9. Brake system
- 10. An electric equipment
10.1. Removal and installation of the block of safety locks
10.2. The storage battery
# 10.3. Ignition system
10.4. Removal and installation of a combination of devices
# 10.5. A cleaner and a windscreen washer
# 10.6. A cleaner and a washer of glass of a door of a back
10.7. Replacement of lamps
10.8. Removal and headlight installation
10.9. Removal and installation of a back lantern
10.10. Replacement of an additional lantern of a signal of braking
10.11. Switches and switches
10.12. Removal and installation of sound signals
10.13. Removal and installation динамиков
10.14. Removal and aerial installation
# 11. A body
# 12. Electroschemes
|
LAMPS DISTANT AND THE PASSING LIGHT
Removal of a cover of a headlight
Replacement of a lamp of a headlight
|
1 – connecting колодка;
2 – a lamp;
3 – a spring clamp |
Arrangement of lamps in a headlight
|
1 – a headlight lamp;
2 – a passing light lamp;
3 – a lamp of dimensional light |
The prevention Galogenovye lamps at work heat up to a heat. Do not concern flasks of a lamp with hands: on it there are fatty traces because of which the lamp will quickly fuse. If you have unintentionally concerned flasks, wipe its pure rag moistened with spirit.
PERFORMANCE ORDER |
1. For convenience of work with the left headlight remove a lateral cover of the storage battery. |
2. Disconnect a wire from the plug - the storage battery. |
3. Having pressed two spring clamps 1 (fig. Removal of a cover of a headlight see), uncover 2 headlights. |
4. Disconnect колодку 1 (fig. Replacement of a lamp of a headlight see) with wires from a cartridge of a lamp of a headlight. |
5. Deduce the ends of a spring clamp 3 from hooks on the case of a headlight and turn a clamp aside. |
6. Take out a lamp 2 headlights. |
7. Insert a new lamp, without concerning with fingers of a glass flask. Thus ledges on the headlight case should enter into apertures on a lamp socle. |
8. Turn a spring clamp into place and hook on its ends for hooks on the headlight case. Then connect to a lamp cartridge колодку with wires. |
9. Establish into place and fix a headlight cover. |
10. A lamp 2 (fig. the Arrangement of lamps in a headlight see) passing light replace the same as a headlight lamp. |
|
LAMP OF DIMENSIONAL LIGHT
PERFORMANCE ORDER |
1. Disconnect a wire from the plug - the storage battery. |
2. Having pressed two spring clamps 1 (fig. Removal of a cover of a headlight see), uncover 2 headlights. |
3. Having pulled on itself, take out a cartridge with a lamp 3 (fig. the Arrangement of lamps in a headlight see) dimensional light from the headlight case. |
4. Take out a lamp of dimensional light from a cartridge, insert a new lamp and establish a cartridge into place. |
5. Establish into place and fix a headlight cover. |
|
LAMP OF THE FORWARD INDEX OF TURN
Replacement of a lamp of the forward index of turn
|
1 – a cartridge;
2 – the case of the index of turn;
3 – a headlight |
PERFORMANCE ORDER |
1. Disconnect a wire from the plug - the storage battery. |
2. Take out a cartridge 1 (fig. Replacement of a lamp of the forward index of turn see) with a lamp from the case 2 indexes of turn, having turned it counter-clockwise. |
3. Press a lamp, turn it counter-clockwise and take out from a cartridge. |
4. Insert a new lamp into a cartridge and fix it, having turned clockwise against the stop. |
|
LAMP OF THE ANTIFOG HEADLIGHT
Removal of a ventilating lattice
|
1 – an antifog headlight;
2 – a ventilating lattice;
3 – the forward buffer |
Removal of an antifog headlight
|
1 – an antifog headlight;
2 – screws;
3 – the gauge of temperature of air |
Replacement of a lamp of an antifog headlight
|
1 – an antifog headlight;
2 – the gauge of temperature of air;
3 – a spring clamp;
4 – a wire tip;
5 – a lamp |
PERFORMANCE ORDER |
1. Disconnect a wire from the plug - the storage battery. |
2. By means of a screw-driver wring out two clamps in the places specified by arrows on fig. Removal of a ventilating lattice, a ventilating lattice 2 (since the clamp nearest to the centre) and remove a lattice 2 from the forward buffer. |
3. Turn away screws 2 (fig. Removal of an antifog headlight see) headlight fastenings. Pay attention that the top screw of the left headlight крепит also the gauge of 3 temperatures of air. |
4. Take out a headlight 1 (fig. Replacement of a lamp of an antifog headlight) from the buffer see and remove заглушку. |
5. Disconnect a tip of 4 wires. |
6. Deduce the ends of a spring clamp 3 from hooks on the case of a headlight and turn a clamp aside. |
7. Take out a lamp 5 with a wire. |
8. Insert a new lamp, without concerning with fingers of a glass flask. Thus ledges on the headlight case should enter into apertures on a lamp cartridge. |
9. Turn a spring clamp into place, hook on its ends for hooks on the case of a headlight and connect to колодке with a wire. Establish заглушку. |
10. Establish into place an antifog lantern and a ventilating lattice. |
|
LAMPS OF THE BACK LANTERN (THE BODY THE HATCHBACK)
Removal of the holder of lamps of a back lantern
|
1 – latches;
2 – the holder of lamps;
3 – a lantern |
The holder with lamps of a back lantern
|
1 – a lamp of a signal of braking;
2 – a lamp of the index of turn;
3 – a lamp of light of a backing;
4 – a lamp of dimensional light (in the left lantern it is also an antifog lamp);
5 – the holder of lamps |
PERFORMANCE ORDER |
1. Disconnect a wire from the plug - the storage battery. |
2. Open a door of a back and cast away upholstery edge to get access to a lantern 3 (fig. Removal of the holder of lamps of a back lantern see). |
3. Compress two plastic latches 1 on the top part of the holder of 2 lamps that they left gearing with the lantern case. |
4. Take out the holder of 2 lamps from the lantern case. |
5. Press fused lamp, turn it counter-clockwise and take out from the holder 5 (fig. the Holder with lamps of a back lantern see). |
6. Insert a new lamp in the holder and fix it, having turned clockwise against the stop. |
7. Insert into the lantern case at first the bottom part of the holder, then top, having fixed the holder in the case. Clicks should be thus audible. |
8. Establish an upholstery into place. |
|
LAMPS OF THE BACK LANTERN (THE BODY THE SEDAN AND THE VERSATILE PERSON)
Kind from a luggage carrier on a back lantern of bodies a sedan and the versatile person
|
1 – a back lantern;
2 – the holder of lamps |
PERFORMANCE ORDER |
1. Disconnect a wire from the plug - the storage battery. |
2. Open a luggage carrier cover. |
3. Accurately uncover the luggage carrier upholstery, closing access to a lantern 1 (fig. the Kind from a luggage carrier on a back lantern of bodies a sedan and the versatile person see). |
4. Turn away screws of fastening and take out the holder of 2 lamps from the lantern case. |
5. Press fused lamp, turn it counter-clockwise and take out from the holder. |
6. Insert a new lamp in the holder and fix it, having turned clockwise against the stop. |
7. Establish the holder in the case of a headlight and fix its screws. |
8. Establish into place an upholstery cover. |
|
LAMP OF THE LANTERN OF ILLUMINATION OF LICENSE PLATE
Fastening of a lantern of illumination of licence plate
|
1 – screws;
2 – a lantern;
3 – a luggage carrier cover |
PERFORMANCE ORDER |
1. Disconnect a wire from the plug - the storage battery. |
2. Open a luggage carrier cover. |
3. Turn away two screws 1 (fig. Fastening of a lantern of illumination of licence plate see) fastenings of a lantern of illumination of licence plate. |
4. Take out a lantern 2 of a luggage carrier cover. |
5. Take out a lamp and insert the new. |
6. Establish a lantern into place so that the rubber sealant was located exactly, without folds. Fix a lantern screws. |
|
LAMPS OF THE PLAFOND OF ILLUMINATION OF SALON AND DIRECTIONAL LIGHT
Plafond of illumination of salon
|
1 – рассеиватель;
2 – a ceiling upholstery |
PERFORMANCE ORDER |
1. Disconnect a wire from the plug - the storage battery. |
2. Accurately having hooked a screw-driver in a forward part (it is specified by an arrow), remove рассеиватель 1 (see fig. the Plafond of illumination of salon). |
3. Take out a lamp of a plafond of illumination of salon and insert the new. |
4. For replacement of a lamp of a directional light take out it from a cartridge and establish the new. |
5. Establish рассеиватель upside-down and fix it in a ceiling upholstery. |
|
LAMP OF THE PLAFOND OF ILLUMINATION OF THE LUGGAGE CARRIER (THE BODY THE HATCHBACK AND THE VERSATILE PERSON)
Removal of a plafond of illumination of a luggage carrier (a body a hatchback and the versatile person)
PERFORMANCE ORDER |
1. Disconnect a wire from the plug - the storage battery. |
2. Open a door of a back and remove a back shelf. |
3. Accurately having hooked a screw-driver in a place specified by an arrow on fig. Removal of a plafond of illumination of a luggage carrier (a body a hatchback see and the versatile person), take out a plafond from a luggage carrier upholstery. |
4. Disconnect from a wire plafond. |
5. Take out a lamp and insert the new. |
6. Connect to a wire plafond. |
7. Establish in an upholstery at first a forward part of a plafond, and then, having pressed a back part, fix it. |
|
LAMP OF THE PLAFOND OF ILLUMINATION OF THE LUGGAGE CARRIER (THE BODY THE SEDAN)
Removal of a plafond of illumination of a luggage carrier (a body a sedan)
|
1 – a plafond;
2 – connecting колодка;
3 – a clamp of the case of a plafond;
4 – the plafond case
|
PERFORMANCE ORDER |
1. Disconnect a wire from the plug - the storage battery. |
2. Open a back door. |
3. Accurately having hooked a screw-driver in a place specified by an arrow on fig. Removal of a plafond of illumination of a luggage carrier (a body a sedan), take out a plafond 1. |
4. Disconnect from a plafond 1 колодку 2 with wires. |
5. Wring out a clamp 3 and remove the case 4 plafonds. |
6. Take out a lamp and insert the new. |
7. Establish the case and connect to a plafond колодку with wires. |
8. Establish in an upholstery at first a back part of a plafond, and then, having pressed a forward part, fix it. |
|
LAMP OF THE PLAFOND OF ILLUMINATION OF THE WARE BOX
Removal of a plafond of illumination of a ware box
PERFORMANCE ORDER |
1. Disconnect a wire from the plug - the storage battery. |
2. Open a cover of a ware box. |
3. Accurately having hooked a screw-driver in a place specified by an arrow on fig. Removal of a plafond of illumination of a ware box, take out a plafond. |
4. Having pressed clamps, disconnect from a plafond колодку with wires. |
5. Take out a lamp and insert the new. |
6. Connect to a plafond колодку with wires. |
7. Accurately press a plafond into a lateral wall of a ware box, since its bottom part. |
|
LAMP OF THE ALARM LANTERN AT DOORS
Replacement of a lamp of an alarm lantern at doors
|
1 – a lantern;
2 – колодка |
PERFORMANCE ORDER |
1. Disconnect a wire from the plug - the storage battery. |
2. Accurately having hooked a screw-driver, take out a lantern 1 (fig. Replacement of a lamp of an alarm lantern at doors see) of a door. |
3. Disconnect from a lantern колодку 2 with wires. |
4. Take out a lamp and insert the new. |
5. Connect to a lantern колодку with wires. |
6. Accurately press a lantern into a door. |
|
LAMP OF THE LATERAL REPEATER OF THE INDEX OF TURN
Details of the lateral repeater of the index of turn
|
1 – the repeater case;
2 – a lamp;
3 – a protective cover;
4 – a lining |
PERFORMANCE ORDER |
1. Disconnect a wire from the plug - the storage battery. |
2. Turn away two screws of fastening локаря in the wheel niches shown by arrows on fig. of the Detail of the lateral repeater of the index of turn. |
3. From the interior of a wing compress plastic latches and push out the repeater outside. |
4. Remove the case 1 from a protective cover 3. |
5. Replace a lamp 2 and establish on a cover 3 case 1. |
6. Establish the repeater in an aperture of a wing and press it to a wing so that it was fixed. Thus pay attention that wider latch of the case 1 should be directed towards a forward part of the car. |
|
|
|