Skoda Fabia

Since 2000 of release



Shkoda Fabija
# 1.1. The car description
# 2. The engine
# 3. Greasing system
# 4. The power supply system
# 5. Cooling system
# 6. System of release of the fulfilled gases
# 7. Transmission and a running gear
# 8. A steering
# 9. Brake system
# 10. An electric equipment
- 11. A body
   11.1. Removal and installation of a skeleton of a motor compartment
   - 11.2. A forward door
      11.2.1. Removal and installation
      11.2.2. Replacement of the cylinder of the lock
      11.2.3. Removal and installation of the external handle of a door
      11.2.4. Removal and lock installation
      11.2.5. Replacement of sealants
   # 11.3. A back door
   # 11.4. Seats
   # 11.5. Seat belts
   11.6. Removal and installation of the panel of devices
   11.7. Removal and tjagovo-drawbar installation
   # 11.8. A heater
# 12. Electroschemes




11.2.3. Removal and installation of the external handle of a door
THE GENERAL DATA

Removal of the external handle of a door

1 – the external handle;

2 – a draught tip

Spring connection to the lever of the external handle

1 – a hook;

2 – draught of the external handle;

3 – the lever of the external handle;

4 – a spring

PERFORMANCE ORDER
1. Remove the lock cylinder.
2. Press the handle 1 (fig. Removal of the external handle of a door) to the panel of a door see and disconnect a tip of 2 draughts from the handle 1.
3. Take out the handle from a door, having deduced a hook in a forward part of the handle from gearing with the holder 4 (fig. of the Detail of the lock of a door see).
4. Get a hook on a forward part of the handle in gearing with the holder 4 and insert the handle 6 into place.
5. Press the handle 1 (fig. Removal of the external handle of a door) to the panel of a door see and connect to it a tip of draught 2.
6. Check up lock work. If the handle does not come back in a starting position, means, the end оттяжной springs 4 (fig. spring Connection to the lever of the external handle see) has jumped out of the lever 3. To connect a spring to the lever, insert into an aperture under the cylinder of the lock a hook 1, hook it on the end of a spring 4 and enter it into a hook of the lever 3.
7. Establish into place the lock cylinder.