Skoda Fabia

Since 2000 of release


Shkoda Fabija
# 1.1. The car description
# 2. The engine
# 3. Greasing system
# 4. The power supply system
# 5. Cooling system
# 6. System of release of the fulfilled gases
# 7. Transmission and a running gear
# 8. A steering
# 9. Brake system
# 10. An electric equipment
- 11. A body
   11.1. Removal and installation of a skeleton of a motor compartment
   # 11.2. A forward door
   # 11.3. A back door
   - 11.4. Seats
      11.4.1. Removal and installation of a forward seat
      11.4.2. Dismantling of a forward seat
      11.4.3. Removal and installation of a back seat
   # 11.5. Seat belts
   11.6. Removal and installation of the panel of devices
   11.7. Removal and tjagovo-drawbar installation
   # 11.8. A heater
# 12. Electroschemes




11.4.3. Removal and installation of a back seat
THE GENERAL DATA

Fastening of a back of a back seat

 1 – a clamp;

2 – a finger;

3 – a lateral support;

4 – an average support;

5 – a back;

6 – a protective cap;

7 – a back arm

PERFORMANCE ORDER
1. Remove both headrests from seat backs.
2. Raise a first line of a pillow 1 (fig. of Otkidyvanie of a pillow of a back seat see) back seat. Then, having pulled it for back edge, establish a pillow 2 (fig. in subsection 1.9 item 3 see) vertically behind backs of forward seats.
3. Deduce wire clamps 1 from gearing, having wrung out them in the directions specified by arrows.
4. Take out a pillow from the car.
5. Release backs 2 (fig. in subsection 1.9 item 4 see) seats, having extended the button of 1 clamp, and cast away them in horizontal position.
6. Having wrung out a screw-driver a clamp 1 (fig. Fastening of a back of a back seat see), take out upwards a finger of 2 seats from a lateral support 3.
7. Remove a protective cap 6.
8. Remove from an axis of an average support 4 arm of 7 backs.
9. Take out a back from salon.
10. Similarly remove the second back.
11. Establish a back seat upside-down.