Skoda Fabia

Since 2000 of release



Shkoda Fabija
# 1.1. The car description
- 2. The engine
   2.1. Removal of the top casing of the engine
   # 2.2. Installation of the piston of the first cylinder in position ВМТ of a step of compression
   2.3. Replacement of a belt of a drive of the generator
   # 2.4. Replacement and adjustment of a tension of a belt of a drive of a camshaft
   2.5. Replacement of a chain of a drive of a camshaft
   2.6. Selection of a distributive gear wheel of a cranked shaft
   2.7. Replacement of a lining of a head of the block of cylinders
   2.8. Replacement of an epiploon of a camshaft
   2.9. Replacement маслосъемных caps
   2.10. Replacement of a forward epiploon of a cranked shaft
   2.11. A back epiploon of a cranked shaft
   - 2.12. Repair of a head of the block of cylinders
      2.12.1. Dismantling
      2.12.2. Дефектовка
      2.12.3. Assemblage
      2.12.4. Grinding in of valves
      2.12.5. Adjustment of a starting position of hydropushers of valves
      2.12.6. Check of hydropushers of valves of engines of 1,0 l, 37 kw and 1,4 l, 50 kw
      2.12.7. Removal and engine installation
   # 2.13. Engine repair
# 3. Greasing system
# 4. The power supply system
# 5. Cooling system
# 6. System of release of the fulfilled gases
# 7. Transmission and a running gear
# 8. A steering
# 9. Brake system
# 10. An electric equipment
# 11. A body
# 12. Electroschemes




2.12.5. Adjustment of a starting position of hydropushers of valves
THE GENERAL DATA

ENGINES of 1,0 l, 37 kw And 1,4 l of 50 kw

After removal of a head of the block or details of a drive of valves it is necessary to adjust a starting position of hydropushers of valves.

PERFORMANCE ORDER
1. Turn a cranked shaft so that both valves of the fourth cylinder have been opened.
2. Ослабьте an inhaling of counternuts at коромысел the first cylinder (1 – a counternut; 2 – the adjusting screw; 3 – коромысло the valve; 4 – the valve; 5 – a plastic wedge).
3. Turn out adjusting screws 2 so that between коромыслами 3 and valves 4 there was an appreciable backlash.
4. Screw adjusting screws before contact коромысел with valves, and then on two turns.
5. Keeping adjusting screws in this position, tighten counternuts.
6. Adjust a starting position of other hydropushers, turning a cranked shaft according to the table.

Position of a cranked shaft at adjustment of a starting position of hydropushers


The cylinder with open valves
The adjustable cylinder
The fourth
The first
The third
The second
The second
The third
The first
The fourth