Skoda Fabia

Since 2000 of release



Shkoda Fabija
# 1.1. The car description
- 2. The engine
   2.1. Removal of the top casing of the engine
   - 2.2. Installation of the piston of the first cylinder in position ВМТ of a step of compression
      2.2.1. Petrol engines of 1,4 l, 55 and 74 kw
      2.2.2. Diesel engines
   2.3. Replacement of a belt of a drive of the generator
   # 2.4. Replacement and adjustment of a tension of a belt of a drive of a camshaft
   2.5. Replacement of a chain of a drive of a camshaft
   2.6. Selection of a distributive gear wheel of a cranked shaft
   2.7. Replacement of a lining of a head of the block of cylinders
   2.8. Replacement of an epiploon of a camshaft
   2.9. Replacement маслосъемных caps
   2.10. Replacement of a forward epiploon of a cranked shaft
   2.11. A back epiploon of a cranked shaft
   # 2.12. Repair of a head of the block of cylinders
   # 2.13. Engine repair
# 3. Greasing system
# 4. The power supply system
# 5. Cooling system
# 6. System of release of the fulfilled gases
# 7. Transmission and a running gear
# 8. A steering
# 9. Brake system
# 10. An electric equipment
# 11. A body
# 12. Electroschemes




2.2. Installation of the piston of the first cylinder in position ВМТ of a step of compression
THE GENERAL DATA

The prevention

Turn a cranked shaft only clockwise (towards shaft rotation) for a bolt of fastening of a pulley of a drive of the generator. It is forbidden to turn a cranked shaft for a camshaft pulley.


Installation of the piston of the first cylinder in position ВМТ of a step of compression is necessary that at the work, connected with removal of a belt of a drive of a camshaft, installation of phases timing was not broken.

Expose ВМТ on labels on pulleys of camshafts as at installation on a label on a pulley of a drive of the generator in ВМТ there can be a piston either the first, or the fourth cylinder. Having established ВМТ on a camshaft pulley, be convinced of coincidence of labels on a pulley of a drive of the generator or a pulley of a cranked shaft. If they do not coincide, means, installation of phases timing is broken, in this case remove a belt of a drive of a camshaft and turn a cranked shaft before coincidence of labels.