Skoda Fabia

Since 2000 of release



Shkoda Fabija
# 1.1. The car description
# 2. The engine
# 3. Greasing system
- 4. The power supply system
   4.1. Removal and installation of the air filter
   4.2. Replacement of a filtering element of the air filter
   4.3. Replacement of the gauge of the index of level of fuel
   4.4. Removal and installation of a fuel tank
   4.5. Check of the air valve
   4.6. Check of the gravitational valve
   4.7. Replacement of the fuel filter
   4.8. Check of the valve of heating of fuel
   4.9. Replacement of an adsorber of system of catching of steams of fuel
   4.10. Replacement of a fuel radiator
   4.11. Removal and installation of the vacuum pump of the diesel engine
   4.12. Removal and installation of an inlet pipe of the engine
   4.13. Removal and installation of a pedal of an accelerator
   # 4.14. Removal and installation of atomizers
   4.15. Check of a feed circuit of atomizers of the petrol engine
   4.16. Check of resistance of a pump-atomizer
   4.17. Check of candles накаливания the diesel engine of 1,9 l, 47 kw
   4.18. Check of a feed circuit of candles накаливания
   4.19. Check of the gauge of temperature of a cooling liquid
   4.20. Check of the gauge of temperature of air arriving in the engine
   4.21. Check of the gauge of temperature of fuel of the diesel engine of 1,9 l, 74 kw
   4.22. Check of the gauge of frequency of rotation of a cranked shaft
   4.23. Check of a drive throttle заслонки
   4.24. Check of the gauge of position of a camshaft
   4.25. Check элекромагнитного the valve рециркуляции the fulfilled gases
   4.26. Check of the relay of the fuel pump of engines of 1,4 l, 55 and 74 kw
   4.27. Check of the electromagnetic valve of a purge of an adsorber
   4.28. Removal and installation турбокомпрессора
   4.29. Removal and installation of an intermediate cooler of air
   4.30. Check of the valve of pressure of pressurisation
# 5. Cooling system
# 6. System of release of the fulfilled gases
# 7. Transmission and a running gear
# 8. A steering
# 9. Brake system
# 10. An electric equipment
# 11. A body
# 12. Electroschemes




4.16. Check of resistance of a pump-atomizer
PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Remove the top casing of the engine (subsection 2.1 see).
3. Disconnect колодку II plait of atomizers from колодки I plait of wires.
4. Connect an ohmmeter to following contacts колодки 2: the first cylinder – contacts 7 and 5; the second cylinder – 7 and 3; the third cylinder – contacts 7 and 2; the fourth cylinder – contacts 7 and 6. In all cases resistance should be nearby 0,5 Ohm.
5. If resistance of any pump-atomizer differs from specified, measure resistance directly on pump-atomizer contacts.
6. For this purpose remove the top cover of a belt of a drive of a camshaft, a cover of a head of the block of cylinders, disconnect from a pump-atomizer колодку with wires and measure resistance.
7. If it differs again from specified, replace the pump-atomizer. If resistance in norm, replace atomizer wires.