Skoda Fabia

Since 2000 of release



Shkoda Fabija
# 1.1. The car description
# 2. The engine
# 3. Greasing system
# 4. The power supply system
# 5. Cooling system
# 6. System of release of the fulfilled gases
- 7. Transmission and a running gear
   # 7.1. A transmission
   - 7.2. A forward suspension bracket
      7.2.1. Removal and installation of a telescopic rack
      7.2.2. Repair of a telescopic rack
      7.2.3. Replacement of a spherical support
      7.2.4. Removal and installation of the lever of a forward suspension bracket
      7.2.5. Removal and installation of an arm of a forward suspension bracket
      7.2.6. Replacement резинометаллической support
      7.2.7. Removal and installation of the stabilizer of cross-section stability
   # 7.3. A back suspension bracket
# 8. A steering
# 9. Brake system
# 10. An electric equipment
# 11. A body
# 12. Electroschemes




7.2.6. Replacement резинометаллической support
THE GENERAL DATA

Installation резинометаллической support in a beam arm

1 – a ledge on a support;

2 – a label on an arm

It is possible to replace a Rezinometallichesky support, without removing an arm of a beam of a forward suspension bracket from the car.

PERFORMANCE ORDER
1. Remove the lever of a forward suspension bracket from the car (subsection 7.2.4 see).
2. By means of a stripper выпрессуйте an old support from an arm.
3. Запрессуйте a new support in an arm. Thus the ledge 1 should coincide with a label 2 on an arm.
The prevention

At запрессовке it is supposed grease it only with greasing G294 421 A1. All other lubricants can lead to support destruction.


4. Establish the lever of a forward suspension bracket on the car.