Skoda Fabia

Since 2000 of release



Shkoda Fabija
# 1.1. The car description
# 2. The engine
# 3. Greasing system
# 4. The power supply system
# 5. Cooling system
# 6. System of release of the fulfilled gases
- 7. Transmission and a running gear
   # 7.1. A transmission
   # 7.2. A forward suspension bracket
   - 7.3. A back suspension bracket
      7.3.1. Removal and installation of a nave of a wheel (the drum-type brake mechanism)
      7.3.2. Removal and installation of a nave of a wheel (the disk brake mechanism)
      7.3.3. Removal and pin installation (drum-type brake to mechanisms)
      7.3.4. Removal and pin installation (the disk brake mechanism)
      7.3.5. Removal and shock-absorber installation
      7.3.6. Removal and spring installation
      7.3.7. Removal and installation of a back suspension bracket
      7.3.8. Check and adjustment of corners of installation of wheels
# 8. A steering
# 9. Brake system
# 10. An electric equipment
# 11. A body
# 12. Electroschemes




7.3.1. Removal and installation of a nave of a wheel (the drum-type brake mechanism)
THE GENERAL DATA

The prevention

At an exit of the bearing of a nave out of operation it is recommended to replace the bearing in gathering with a nave.


PERFORMANCE ORDER
1. Cautiously bring down a protective cap 4 (fig. of the Detail of a back suspension bracket with drum-type brakes) nuts of a nave see and remove it.
2. Ослабьте an inhaling of a nut of 5 naves (a nut двенадцатигранная) and bolts of 1 fastening of a corresponding wheel.
3. Lift and establish on reliable support a back part of the car.
4. Remove a wheel, having turned on definitively bolts of its fastening.
5. Be convinced that the lever of a lay brake is lowered against the stop downwards (the lay brake is released).
6. Reduce brake колодки (subsection 9.5.2 see).
7. Turn away the screw of 2 fastenings of a brake drum to a nave.
8. Remove a brake drum 3. At the complicated removal shift a drum a rubber or polymeric hammer.
9. Definitively turn away a nut of 5 naves.
10. Cautiously, without warping, remove a nave 6 from a pin.
11. Напрессуйте a nave 6 on a pin 19, watching that the nave did not warp.
12. Screw a new nut of 5 naves. Definitively tighten a nave nut on the car standing on the earth.
13. Establish a drum and a wheel.
14. Necessarily replace the broken or deformed cap of 4 naves.
15. Some times press a brake pedal that колодки have occupied working position.

The inhaling moments, Нм

Nut of a nave of a wheel
70, then to tighten on 30
The screw of fastening of a brake drum
4
Bolts of fastening of a wheel
120