Skoda Fabia

Since 2000 of release



Shkoda Fabija
# 1.1. The car description
# 2. The engine
# 3. Greasing system
# 4. The power supply system
# 5. Cooling system
# 6. System of release of the fulfilled gases
- 7. Transmission and a running gear
   # 7.1. A transmission
   # 7.2. A forward suspension bracket
   - 7.3. A back suspension bracket
      7.3.1. Removal and installation of a nave of a wheel (the drum-type brake mechanism)
      7.3.2. Removal and installation of a nave of a wheel (the disk brake mechanism)
      7.3.3. Removal and pin installation (drum-type brake to mechanisms)
      7.3.4. Removal and pin installation (the disk brake mechanism)
      7.3.5. Removal and shock-absorber installation
      7.3.6. Removal and spring installation
      7.3.7. Removal and installation of a back suspension bracket
      7.3.8. Check and adjustment of corners of installation of wheels
# 8. A steering
# 9. Brake system
# 10. An electric equipment
# 11. A body
# 12. Electroschemes




7.3.3. Removal and pin installation (drum-type brake to mechanisms)
THE GENERAL DATA

The prevention

Editing of a carving of a pin is forbidden. With the damaged carving it is necessary to replace a pin.


PERFORMANCE ORDER
1. On cars with ABS disconnect a wire from the plug - the storage battery, disconnect колодку with wires from the gauge 24 (fig. of the Detail of a back suspension bracket with drum-type brakes see) frequencies of rotation of a wheel, turn away a bolt of 26 fastenings and remove the gauge 24.
2. Remove a wheel nave (subsection 7.3.1 see).
3. Turn away a nut of fastening and disconnect a brake tube 20 from the wheel cylinder. Muffle a tube aperture, for example a cap of the valve of release of air.
4. Turn away four bolts of 7 fastenings and remove a brake board with a pin.
5. Take out a pin 19 of a brake board.
6. Establish a pin upside-down. Thus bolts of fastening of a pin with a brake board replace new.
7. Pump over brake system.

The inhaling moments, Нм

Nut of fastening of a brake tube
14
Bolts of fastening of a pin with a brake board
30, then to tighten on 90
Bolts of fastening of a wheel
120