Skoda Fabia

Since 2000 of release



Shkoda Fabija
# 1.1. The car description
# 2. The engine
# 3. Greasing system
# 4. The power supply system
# 5. Cooling system
# 6. System of release of the fulfilled gases
# 7. Transmission and a running gear
# 8. A steering
- 9. Brake system
   # 9.1. Pedal knot
   9.2. The vacuum amplifier
   9.3. The main brake cylinder
   9.4. A pressure regulator (on models without ABS)
   # 9.5. The brake mechanism of a forward wheel of type FS III
   # 9.6. The brake mechanism of a forward wheel of type FS II
   # 9.7. The brake mechanism of a back wheel (drum-type)
   # 9.8. The brake mechanism of a back wheel (disk)
   - 9.9. A lay brake
      9.9.1. Adjustment of a lay brake with back drum-type brakes
      9.9.2. Adjustment of a lay brake with back disk brakes
      9.9.3. Lever replacement
      9.9.4. Replacement of cables
      9.9.5. Replacement of a brake liquid
      9.9.6. Prorolling of brake system
   # 9.10. Antiblocking system (ABS)
# 10. An electric equipment
# 11. A body
# 12. Electroschemes


Фильтр фп-6 смотри здесь.


9.9. A lay brake

9.9.1. Adjustment of a lay brake with back drum-type brakes
THE GENERAL DATA

The equalizer of cables of a drive of a lay brake
1 – the equalizer;

2 – cables;

3 – an adjusting nut;

4 – draught
PERFORMANCE ORDER
1. Remove the floor console.
2. Be convinced that the lever of a lay brake has been lowered against the stop downwards.
3. For self-installation of elements of a lay brake some times sharply press a brake pedal, and then three times tighten and lower the lever of a lay brake.
4. Lift the lever on one click (from completely lowered position).
5. Tighten an adjusting nut 3 (fig. the Equalizer of cables of a drive of a lay brake see) until when back wheels can be turned hardly hands. Keep in mind that an adjusting nut самоконтрящаяся, therefore from it some coils of a carving of draught always should act, differently will not be самоконтрящегося effect.
6. Lower the lever of a lay brake against the stop downwards and turn hands back wheels. They should rotate in regular intervals, without jammings.
7. Lift the lever on four clicks. Wheels should not be turned. Otherwise repeat adjustment.
8. Establish the floor console.