Skoda Fabia

Since 2000 of release

Shkoda Fabija
# 1.1. The car description
# 2. The engine
# 3. Greasing system
# 4. The power supply system
# 5. Cooling system
# 6. System of release of the fulfilled gases
# 7. Transmission and a running gear
# 8. A steering
- 9. Brake system
   # 9.1. Pedal knot
   9.2. The vacuum amplifier
   9.3. The main brake cylinder
   9.4. A pressure regulator (on models without ABS)
   # 9.5. The brake mechanism of a forward wheel of type FS III
   # 9.6. The brake mechanism of a forward wheel of type FS II
   # 9.7. The brake mechanism of a back wheel (drum-type)
   # 9.8. The brake mechanism of a back wheel (disk)
   - 9.9. A lay brake
      9.9.1. Adjustment of a lay brake with back drum-type brakes
      9.9.2. Adjustment of a lay brake with back disk brakes
      9.9.3. Lever replacement
      9.9.4. Replacement of cables
      9.9.5. Replacement of a brake liquid
      9.9.6. Prorolling of brake system
   # 9.10. Antiblocking system (ABS)
# 10. An electric equipment
# 11. A body
# 12. Electroschemes

9.9.4. Replacement of cables

PERFORMANCE ORDER

1. Remove the floor console.

2. Raise and establish on reliable support a back part of the car.

3. Remove a wheel, preliminary having weakened bolts of its fastening on the car standing on the earth.

4. Lower the lever of a lay brake against the stop downwards.

5. Ослабьте an adjusting nut 4 (fig. Installation of the lever of a lay brake see) and disconnect tips of cables 7 from the equalizer 3.

6. Disconnect the holder 9 (fig. of the Detail of a back suspension bracket with drum-type brakes see) from a beam of a back suspension bracket.

7. Disconnect cables from spring holders 16.

The drum-type brake mechanism

8. Remove a brake drum.

9. Disconnect a cable from the lever 8 (fig. of the Detail of the brake drum-type mechanism of a back wheel see) manual drive.

10. Pull out a tip of a cable from a brake board 14.

11. Take out a cable 7 (fig. Installation of the lever of a lay brake see) of a directing tube 6.

The disk brake mechanism

12. Having hooked a screw-driver, remove spring скобу 1 (fig. the Detachment of a cable of a drive of a lay brake see).

13. Having wrung out the lever 6 manual drives in a direction specified by an arrow, disconnect from it a cable 4 drives of a lay brake.

14. Take out a cable 7 (fig. Installation of the lever of a lay brake see) of a directing tube 6.

15. Establish a cable upside-down.

16. Thus replace the holder 9 (fig. of the Detail of a back suspension bracket with drum-type brakes see) cable. The ring on a cable cover should be between collars of the holder 9.

17. Adjust a lay brake.