Skoda Fabia

Since 2000 of release

11.8.9. Removal and installation of a radiator of a heater

THE GENERAL DATA

Heater radiator

1 – a casing; 2 – an electroheating element; 3 – a heater radiator; 4 – a label; 5 – a heater sealant in gathering; 6 – a board sealant передка;

7 – a sealing ring; 8 – a radiator branch pipe; 9 – a bolt; 10 – "a mass" wire; 11 – connecting колодка; 12 – a forward clamp of a casing

Connection of hoses to a heater radiator

1 – a taking away hose; 2 – a bringing hose; 3 – a collar; 4 – a radiator branch pipe; 5 – a bolt

Removal of a casing of a radiator of a heater

1 – spring скобы; 2 – a casing; 3 – an adapter of the bottom air line

On a part of models the electroheating element of a heater which in addition warms up air is established. The element joins the block of engine management depending on temperature of air and a cooling liquid and generator loading at the established handle on the control panel a heater on the maximum heating.

PERFORMANCE ORDER

1. Disconnect a wire from the plug - the storage battery. 2. Remove the floor console. 3. Merge a liquid from system of cooling of the engine or press taking away 1 (fig. Connection of hoses to a heater radiator see) and bringing 2 hoses of a radiator of a heater (if the heater radiator acts in film for replacement, it is necessary to merge a liquid). 4. From outside a motor compartment mark position of a branch pipe 4 heaters and turn away a bolt of 5 its fastenings. Take out a branch pipe and together with hoses put aside. 5. Muffle apertures in a radiator 3 (fig. a heater Radiator see) heater. 6. On models with an electroheating element 2 disconnect колодку 11 with wires from a plait on the left side of a heater and "a mass" wire 10. 7. Remove an adapter 3 (fig. Removal of a casing of a radiator of a heater see) bottom air line. 8. Remove spring скобы 1 fastenings of a casing of a radiator of a heater from three parties. 9. Lower and shift on itself a casing 2 radiators of a heater to deduce from gearing its forward clamp 12 (fig. a heater Radiator see). 10. Take out a casing of 1 radiator of a heater from under the panel of devices on the right side. 11. Take out a radiator 3 heaters from a casing 1. 12. Replace the sealing rings torn or lost elasticity 7 branch pipes. 13. Establish a heater radiator upside-down. Thus pay attention that the label 4 on it, specifying bringing and taking away directions, should be from above. Establish a branch pipe according to earlier made marks, densely having inserted it into a sealant 6 on a board передка. 14. Check up level and if necessary add cooling liquid (at replacement of a radiator of a heater fill in a new liquid in system of cooling of the engine).

The moments of an inhaling of a bolt of fastening of branch pipes of the heat exchanger – 20 Нм.