Skoda Fabia

Since 2000 of release



Shkoda Fabija
# 1.1. The car description
# 2. The engine
# 3. Greasing system
- 4. The power supply system
   4.1. Removal and installation of the air filter
   4.2. Replacement of a filtering element of the air filter
   4.3. Replacement of the gauge of the index of level of fuel
   4.4. Removal and installation of a fuel tank
   4.5. Check of the air valve
   4.6. Check of the gravitational valve
   4.7. Replacement of the fuel filter
   4.8. Check of the valve of heating of fuel
   4.9. Replacement of an adsorber of system of catching of steams of fuel
   4.10. Replacement of a fuel radiator
   4.11. Removal and installation of the vacuum pump of the diesel engine
   4.12. Removal and installation of an inlet pipe of the engine
   4.13. Removal and installation of a pedal of an accelerator
   # 4.14. Removal and installation of atomizers
   4.15. Check of a feed circuit of atomizers of the petrol engine
   4.16. Check of resistance of a pump-atomizer
   4.17. Check of candles накаливания the diesel engine of 1,9 l, 47 kw
   4.18. Check of a feed circuit of candles накаливания
   4.19. Check of the gauge of temperature of a cooling liquid
   4.20. Check of the gauge of temperature of air arriving in the engine
   4.21. Check of the gauge of temperature of fuel of the diesel engine of 1,9 l, 74 kw
   4.22. Check of the gauge of frequency of rotation of a cranked shaft
   4.23. Check of a drive throttle заслонки
   4.24. Check of the gauge of position of a camshaft
   4.25. Check элекромагнитного the valve рециркуляции the fulfilled gases
   4.26. Check of the relay of the fuel pump of engines of 1,4 l, 55 and 74 kw
   4.27. Check of the electromagnetic valve of a purge of an adsorber
   4.28. Removal and installation турбокомпрессора
   4.29. Removal and installation of an intermediate cooler of air
   4.30. Check of the valve of pressure of pressurisation
# 5. Cooling system
# 6. System of release of the fulfilled gases
# 7. Transmission and a running gear
# 8. A steering
# 9. Brake system
# 10. An electric equipment
# 11. A body
# 12. Electroschemes




4.13. Removal and installation of a pedal of an accelerator
THE GENERAL DATA

Removal of a pedal of an accelerator

1 – an arm of pedals;

2 – connecting колодка;

3 – the gauge of position of a pedal of an accelerator;

4 – a nut of fastening of a pedal;

5 – an accelerator pedal

The accelerator pedal is not connected mechanically with throttle заслонкой. On a pedal the gauge of 3 positions of a pedal is established, by pressing a pedal the signal from the gauge arrives in the block of engine management which in turn gives a command on opening throttle заслонки.

In case of need change a pedal 5 in gathering with the gauge 3, as this design not folding.

PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Remove the bottom facing of the panel of devices from outside the driver (subsection 11.6 see).
3. Disconnect колодку 2 with wires from the gauge 3.
4. Turn away three nuts of 4 fastenings and remove a pedal 5 in gathering.
5. Establish a pedal upside-down. The moment of an inhaling of a nut of fastening of a pedal of an accelerator 10 Нм.