Skoda Fabia

Since 2000 of release

7.1.3.7. Removal and installation of a drive of forward wheels

THE GENERAL DATA

Details of a forward suspension bracket

1 – a telescopic rack; 2 – a wheel drive in gathering; 3 – a lock plate; 4 – a bolt of fastening of the case of an internal SHRUS; 5 – a drive of a wheel with internal SHRUS of "Tripod"; 6 – a lock plate ("Tripod"); 7 – a bolt of fastening of a drive ("Tripod"); 8 – a brake disk; 9 – a bolt of fastening of a wheel; 10 – a nave nut; 11 – the screw of fastening of a brake disk; 12 – brake колодка; 13 – a support; 14 – a directing finger;

15 – a protective cap; 16 – a bolt of fastening of a board of a brake; 17 – a nave; 18 – a brake board; 19 – a nut of a spherical finger of a tip of steering draught; 20 – a tip of steering draught; 21 – a rotary fist; 22 – a nut of a coupling bolt; 23 – a coupling bolt; 24 – the gauge of frequency of rotation of a wheel; 25 – a bolt of fastening of the gauge; 26 – a nut of fastening of a rack of the stabilizer; 27 – a rack of the stabilizer of cross-section stability

Выпрессовка шлицевого a tip of an external SHRUS from a nave

1 – a stripper; 2 – a wheel nave

PERFORMANCE ORDER

1. Ослабьте an inhaling of bolts 9 (fig. of the Detail of a forward suspension bracket see) fastenings of a corresponding wheel and a nut of 10 naves of a wheel. 2. Lift and establish on reliable support a forward part of the car. 3. Remove a wheel and локарь wheel niches. 4. Definitively turn away a nut of 10 naves. 5. Turn away six bolts of 4 fastenings of the case of an internal SHRUS to a flange of a semiaxis and remove three lock plates 3. Suspend for the insurance полуось on a wire to a body. 6. Turn a steering wheel against the stop in that party at which the external tip of steering draught of from outside removed drive will be turned outside from a car axis, and take a shaft aside from a semiaxis flange. The prevention On models with the hydraulic booster of a steering do not hold a steering wheel turned in extreme position more than 15 with. 7. By means of a special stripper 1 выпрессуйте шлицевый a tip of an external SHRUS from a nave of 2 wheels (fig. of Vypressovka шлицевого a tip of an external SHRUS from a nave see). In the absence of a stripper it can be made hammer blows through the wooden prorate on an end face шлицевого a tip. 8. Establish a wheel drive upside-down. Thus replace bolts.

The inhaling moments, Нм

Nut of a nave of a wheel	30
Bolts of fastening of the case of an internal SHRUS to a semiaxis flange in two stages on a diagonal:
– The first stage	10
– The second stage:
• М8х48	40
• М10х52	70
Bolts of fastening of the case of an internal SHRUS of type "Tripod" to a semiaxis flange in two stages on a diagonal:
– The first stage	10
– The second stage:
• М8х18	40
• М8х28	40
• М10х23	70
Bolts of fastening of a wheel	120