Skoda Fabia

Since 2000 of release

8.5.8. Replacement of highways of system of the amplifier of a steering

PERFORMANCE ORDER

1. For convenience of work remove the forward buffer. 2. Turn away a cover 9 (fig. Elements of the hydraulic amplifier of a steering) a receiver see and through a bulk mouth remove by means of a rubber pear a working liquid from a receiver. 3. Remove forward wheels. 4. Remove локарь niches of a forward left wheel. 5. Take out a returnable highway 3 of three holders 4. 6. Wring out a spring latch and open the holder 1 (fig. Extraction of a wire and highways from the holder see). Take out from it pressure head 3 and returnable 2 highways. 7. Unclench by means of flat-nose pliers a collar 5 (fig. Connection of highways to the pump unit see) and accurately disconnect a returnable highway 4 from the union of the pump unit. 8. Turn away a nut of 2 fastenings and disconnect a pressure head highway 3 from the pump unit. 9. Muffle the union and a carving aperture of the pump unit. 10. Disconnect a back support 10 (Fastening of the steering mechanism fig. see the car (without the amplifier)) the power unit from a transmission, having turned away two bolts of 9 fastenings (bolts it is necessary to replace new). 11. Lower a beam of a forward suspension bracket (subsection 7.2.5 see) approximately on 40 mm. Thus do not suppose damage of a wire of the gauge of the amplifier of a steering (for reliability the gauge wire can be disconnected from the pump unit). 12. Turn away a hollow bolt 14 (Fastening of the steering mechanism fig. see the car (with the amplifier)) fastenings and disconnect from картера the steering mechanism at first a pressure head highway 16, and then a returnable highway 12, having turned away a nut of its fastening. Muffle apertures in картере the steering mechanism, for example, plastic stoppers. 13. Remove highways. 14. Establish pressure head and returnable highways upside-down, using thus new sealing rings 13 and 15. Pay attention that at a returnable highway 12 sealant 13 round sections. The prevention The highway cannot bend strongly (diameter of a bend not less than 100 mm). 15. After installation add a working liquid and pump over hydraulic system of the amplifier of a steering (subsection 8.5.10 see). 16. Check up and, if necessary, adjust corners of installation of wheels.

The inhaling moments, Нм

Hollow bolt of fastening of a pressure head highway to картеру the steering mechanism	35
Nut of fastening of a pressure head highway to the pump	30
Nut of fastening of a returnable highway to картеру the steering mechanism	30
Bolts of fastening of a wheel	120