Skoda Fabia

Since 2000 of release



Shkoda Fabija
# 1.1. The car description
# 2. The engine
# 3. Greasing system
# 4. The power supply system
# 5. Cooling system
# 6. System of release of the fulfilled gases
# 7. Transmission and a running gear
# 8. A steering
- 9. Brake system
   # 9.1. Pedal knot
   9.2. The vacuum amplifier
   9.3. The main brake cylinder
   9.4. A pressure regulator (on models without ABS)
   # 9.5. The brake mechanism of a forward wheel of type FS III
   # 9.6. The brake mechanism of a forward wheel of type FS II
   # 9.7. The brake mechanism of a back wheel (drum-type)
   # 9.8. The brake mechanism of a back wheel (disk)
   # 9.9. A lay brake
   - 9.10. Antiblocking system (ABS)
      9.10.1. Check of electroconducting ABS
      9.10.2. Removal and installation of the block of management
      9.10.3. Replacement of the block of management
      9.10.4. Replacement of a wire of the gauge of frequency of rotation of a wheel
      9.10.5. Replacement of the gauge of frequency of rotation of a wheel
      9.10.6. Replacement of touch rings of gauges of frequency of rotation of wheels
      9.10.7. Removal and installation of the switch of a signal of braking
# 10. An electric equipment
# 11. A body
# 12. Electroschemes




9.10.7. Removal and installation of the switch of a signal of braking
THE GENERAL DATA

The prevention

It is necessary to replace the switch of a signal of braking with servicing deports as its installation demands certain skill.


PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Remove a ware box from outside the driver.
3. Disconnect колодку with wires from the switch 15 (fig. Pedal knot see) braking signal.
4. Turn the switch counter-clockwise on 45 and take out it from an arm.
5. Put forward completely a switch rod.
6. Grease a rod end face with a thin layer of graphite greasing.
7. Press a brake pedal against the stop, insert the switch into an aperture of an arm and turn it on 45 clockwise, thereby having fixed it. Then release a brake pedal.
8. Connect to the gauge колодку and a wire to the plug - the storage battery.
9. Check up switch work.
10. Establish a ware box from outside the driver.