Skoda Fabia

Since 2000 of release



Shkoda Fabija
# 1.1. The car description
# 2. The engine
# 3. Greasing system
# 4. The power supply system
# 5. Cooling system
# 6. System of release of the fulfilled gases
# 7. Transmission and a running gear
# 8. A steering
# 9. Brake system
- 10. An electric equipment
   10.1. Removal and installation of the block of safety locks
   10.2. The storage battery
   # 10.3. Ignition system
   10.4. Removal and installation of a combination of devices
   # 10.5. A cleaner and a windscreen washer
   # 10.6. A cleaner and a washer of glass of a door of a back
   10.7. Replacement of lamps
   10.8. Removal and headlight installation
   10.9. Removal and installation of a back lantern
   10.10. Replacement of an additional lantern of a signal of braking
   10.11. Switches and switches
   10.12. Removal and installation of sound signals
   10.13. Removal and installation динамиков
   10.14. Removal and aerial installation
# 11. A body
# 12. Electroschemes




10.2. The storage battery
THE GENERAL DATA

Fastening of the storage battery

1 – a bolt;

2 – an arm;

3 – the holder

Fastening of the holder of the storage battery

1 – the holder;

2 – nuts;

3 – a bolt

Removal and installation

PERFORMANCE ORDER
1. Wring out in the parties plastic loops 2 (fig. in subsection 1.52 item 1 see) and cast away the block of 1 safety locks (closed by a cover).
2. Ослабьте an inhaling of a nut 1 (fig. in subsection 1.52 item 2) fastenings of a tip of 3 wires to the plug - the storage battery see and disconnect a tip of a wire from the plug -.
3. Ослабьте an inhaling of a nut of a tip of a wire also disconnect a wire from the plug # the storage battery.
4. Take tips of wires aside
5. Turn away a bolt 1 (fig. Fastening of the storage battery) fastenings see and remove an arm 2.
6. Take out the storage battery from the holder 1 (fig. Fastening of the holder of the storage battery see).
7. To remove the holder, remove from it a cover 1 (fig. in subsection 1.52 item 1 see) with the additional block of safety locks, turn on two nuts 2 (fig. Fastening of the holder of the storage battery see) and a bolt 3.
8. Establish the holder and the storage battery upside-down.
9. At connection of wires to the storage battery tighten fastening nuts so that tips have been put on on plugs densely and they could not be shifted a hand.