Skoda Fabia

Since 2000 of release



Shkoda Fabija
# 1.1. The car description
# 2. The engine
# 3. Greasing system
# 4. The power supply system
# 5. Cooling system
# 6. System of release of the fulfilled gases
# 7. Transmission and a running gear
- 8. A steering
   8.1. Removal and steering wheel installation
   8.2. Removal and installation of returnable and contact rings in gathering
   # 8.3. A steering column
   # 8.4. The steering mechanism (without the amplifier)
   - 8.5. The steering mechanism (with the amplifier)
      8.5.1. Replacement of a tip of steering draught
      8.5.2. Removal of the steering mechanism
      8.5.3. Installation of the steering mechanism
      8.5.4. Replacement of steering draught
      8.5.5. The pump unit
      8.5.6. Check of electric chains of the amplifier of a steering
      8.5.7. Replacement of the gauge of the amplifier of a steering
      8.5.8. Replacement of highways of system of the amplifier of a steering
      8.5.9. Check of level of a working liquid
      8.5.10. Refuelling and removal of air from hydraulic system
      8.5.11. Check and adjustment of corners of installation of wheels
# 9. Brake system
# 10. An electric equipment
# 11. A body
# 12. Electroschemes




8.5.2. Removal of the steering mechanism
THE GENERAL DATA

Elements of the hydraulic amplifier of a steering

1 – the pump unit;
2 – a wire of the gauge of the amplifier
Steering;
3 – a returnable highway;
4 – the holder;
5 – картер the steering mechanism;
6 – the amplifier gauge
Steering;
7 – a pressure head highway;
8 – the holder;
9 – a receiver cover

Fastening of the steering mechanism on the car (with the amplifier)

1 – bolts;
2 – теплоизоляционный the screen;
3 – a plug карданного the hinge;
4 – a coupling bolt;
5 – a lining;
6 – the gauge of the amplifier of a steering;
7 – a bolt of fastening of the gauge of the amplifier
Steering;
8 – a nut;
9 – the rotary lever;
10 – a tip of steering draught in gathering with the spherical hinge;
11 – a counternut;
12 – a returnable highway;
13, 15 – sealing rings;
14 – a hollow bolt;
16 – a pressure head highway;
17 – bolts of fastening of a beam of a forward suspension bracket;
18 – bolts of fastening of the steering mechanism;
19 – bolts of fastening of a back support of the power unit;
20 – a back support of the power unit;
21 – a beam of a forward suspension bracket;
22 – the steering mechanism

PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery. On a part of cars the holder of the storage battery (большего the size) closes a receiver cover. In this case it is necessary to remove the storage battery and its holder (subsection 10.2 see).
2. Establish a steering wheel in the position corresponding rectilinear movement of the car. It is recommended to fix a steering wheel, for example, a sticky tape 2 (fig. in subsection 8.4.2 item 1 see).

The prevention

During repair it is forbidden to turn a steering wheel as the mechanism of a pillow of safety can fail.


3. Turn on two plastic nuts 1 (fig. casing Fastening карданного a shaft of a steering column) casing fastenings карданного a shaft of a steering column see and remove a casing 2.
4. Turn away a coupling bolt 4 (fig. Fastening of a shaft of a steering column to a shaft приводной gear wheels of the steering mechanism see) plugs карданного the hinge.
5. Remove upwards a plug 2 карданного the hinge from a shaft 1 приводной gear wheels of the steering mechanism.
6. If necessary remove the air filter (subsection 4.1 see).
7. 7. Take out a wire 2 (fig. Elements of the hydraulic amplifier of a steering see) gauge of the amplifier of a steering from three holders 4.
8. Remove грязезащитный a guard and forward wheels.
9. On models with the reception pipe of the muffler which are passing under a beam of a forward suspension bracket, remove a reception pipe with neutralizer.
10. Disconnect a back support 20 (Fastening of the steering mechanism fig. see the car (with the amplifier)) from a transmission, having turned away two bolts of 19 fastenings.
11. Turn on on one nut 1 (fig. rack Fastening to a bar of the stabilizer of cross-section stability) fastenings see and disconnect racks 3 from a bar 2 stabilizers from both parties of a suspension bracket.
12. Disconnect tips of both steering draughts from rotary levers (subsection 8.5.1 see).
13. Turn away a cover 9 (fig. Elements of the hydraulic amplifier of a steering) a receiver see and through a bulk mouth remove by means of a rubber pear a working liquid from a receiver.
14. Establish under the steering mechanism capacity for gathering of a liquid which will follow from it at removal.
15. Establish a reliable support under a beam of a forward suspension bracket.
16. Turn away bolts 18 (Fastening of the steering mechanism fig. see the car (with the amplifier)) fastenings of the steering mechanism to a beam 21 forward suspension brackets.
17. Lower a beam of a forward suspension bracket (subsection 7.2.5 see) approximately on 40 mm, without supposing damage of a wire of the gauge and highways of the amplifier of a steering.
18. Turn away a hollow bolt of 14 fastenings and disconnect from картера the steering mechanism at first a pressure head highway 16, then a returnable highway 12, having turned away a nut of its fastening. Muffle apertures of highways and in картере the steering mechanism.
19. Turn away two bolts of 7 fastenings with internal шестигранниками and disconnect the gauge 6 amplifiers of management from the steering mechanism.
20. Cautiously lower a beam 21 forward suspension brackets.
21. Remove the steering mechanism, having deduced it towards a back part of the car.