1. Remove the top casing of the engine (subsection 2.1 see). |
|
2. Disconnect колодку 1 with wires from the gauge of 2 positions of a camshaft. |
3. Include ignition. Measure pressure, having connected the voltmeter between contact 1 колодки and "weight" of the engine, and then between contact 3 and the plug # the storage battery, in both cases the voltmeter should show pressure of the storage battery. |
4. Otherwise check up wires on breakage and short circuit. If wires are serviceable, pressure equally specified, and the engine does not work normally, replace the gauge of position of a camshaft. If wires are serviceable, and the voltmeter shows 0, replace the engine management block. |
|