Skoda Fabia

Since 2000 of release



Shkoda Fabija
- 1.1. The car description
   # 1.2. Technical characteristics of cars
   1.3. Nameplate data
   1.4. Keys
   1.5. Doors
   1.6. A cowl
   1.7. A luggage carrier
   1.8. Adjustment of seats
   1.9. Increase in capacity of a luggage carrier
   1.10. Seat belts
   # 1.11. Pillows of safety of system Airbag
   1.12. Safety of children
   1.13. Car refuelling
   1.14. Fuel
   1.15. Controls
   1.16. A combination of devices
   1.17. The block of control lamps
   1.18. The gear change lever
   1.19. The lever of a lay brake
   1.20. Adjustment of a steering column
   1.21. The switch (lock) of ignition
   1.22. The podrulevoj switch
   1.23. Illumination of devices
   1.24. The proof-reader of headlights
   1.25. The central switch
   1.26. Прикуриватель
   1.27. An ashtray
   1.28. Ware boxes
   1.29. The alarm system
   1.30. Heating of forward seats
   1.31. Heating of back glass
   1.32. The switch антипробуксовочной systems (ASR)
   1.33. Ventilation and salon heating
   1.34. The conditioner
   1.35. Rear-view mirrors
   1.36. Стеклоподъемники with the electric drive
   1.37. Sun-protection peaks
   1.38. The hatch in a roof with the electric drive
   1.39. A sdvizhnaja roof with the electric drive
   1.40. Salon illumination
   1.41. A luggage carrier on a roof
   1.42. The Tjagovo-drawbar
   1.43. Обкатка the car
   1.44. Engine start-up
   1.45. An engine stop
   1.46. Start-up of the engine from an external source
   1.47. Start-up of the engine by towage
   1.48. Car towage
   1.49. A car raising
   # 1.50. Wheels and tyres
   1.51. Cleaners and washers of glasses
   1.52. The storage battery
   1.53. Care of the car
   1.54. The service book
# 2. The engine
# 3. Greasing system
# 4. The power supply system
# 5. Cooling system
# 6. System of release of the fulfilled gases
# 7. Transmission and a running gear
# 8. A steering
# 9. Brake system
# 10. An electric equipment
# 11. A body
# 12. Electroschemes




1.51. Cleaners and washers of glasses
THE GENERAL DATA

Watch, that rubber inserts have not jumped out of holders, differently the screen wiper will scratch glass. If glass dry, before screen wiper inclusion moisten with its washer that brushes have not scratched glass.

If at screen wiper work on glass there are crude places, strips, admissions, replace brushes or rubber inserts.

In winter time before a trip always check, that brushes have not frozen to glass. If it all the same happens, accurately "tear off" their rubber inserts from glass.


The prevention

The polluted rubber inserts of brushes clear a damp rag. At strong pollution use a liquid for a sink of glasses.

You can independently replace rubber inserts of brushes according to the instruction enclosed by manufacturer to the complete set of rubber inserts. It is recommended to spend replacement two times a year.


Removal and installation of brushes of a cleaner of a windscreen

PERFORMANCE ORDER
1. Take away levers with brushes from glass.
2. Turn a brush in relation to the lever on 90 .
3. Press a latch 4 so that the lock ledge 3 on it left an aperture in the lever. Shift a brush 2 downwards on the lever 1 so that it left a hook on the lever, and remove it.
4. For brush installation pass the lever in its aperture so that the cut on a latch has been directed towards the lever, put on a brush a hook of the lever and move upwards on the lever against the stop.

Removal and installation of a brush of a cleaner of back glass

PERFORMANCE ORDER
1. Take away the lever with a brush from glass.
2. Keeping a hand the lever 2 in the top part, take out from it a brush 1. The brush in its average part fastens to the lever 2 by means of a clamp, therefore undertake a brush as it is possible more close to the middle.
3. Establish a brush upside-down, reliably having fixed in the lever.

WASHERS

Arrangement of a tank of a washer

1 – the storage battery;

2 – a stopper of a tank of a washer;

3 – a washer tank

The tank 3 washers is located in подкапотном space on the left side.

Capacity of a tank about 2 l, at models with washers of headlights – about 5,5 l.

In the summer fill in in a tank pure water, in the winter – a nonfreezing liquid. It is recommended to use nonfreezing liquids of manufacture of known firms.

The prevention

Do not fill in in a tank of a washer of a liquid for system of cooling of the engine as they are poisonous.


For refuelling of a tank of a washer turn away its cover. Check up a grid. If it dirty, wash out it and establish into place. Only after that fill in a liquid in a tank.

Constantly watch, that level in a washer tank was sufficient, do not wait operations of the gauge of insufficient level of a liquid in a tank. Do not include a washer if liquid level has fallen below an aperture заборника the pump in a tank – the electric motor of the pump of a washer can fail.

The prevention

Observe safety measures at work with a nonfreezing liquid.