Skoda Fabia

Since 2000 of release



Shkoda Fabija
# 1.1. The car description
# 2. The engine
# 3. Greasing system
# 4. The power supply system
# 5. Cooling system
# 6. System of release of the fulfilled gases
# 7. Transmission and a running gear
# 8. A steering
- 9. Brake system
   # 9.1. Pedal knot
   9.2. The vacuum amplifier
   9.3. The main brake cylinder
   9.4. A pressure regulator (on models without ABS)
   # 9.5. The brake mechanism of a forward wheel of type FS III
   # 9.6. The brake mechanism of a forward wheel of type FS II
   # 9.7. The brake mechanism of a back wheel (drum-type)
   # 9.8. The brake mechanism of a back wheel (disk)
   - 9.9. A lay brake
      9.9.1. Adjustment of a lay brake with back drum-type brakes
      9.9.2. Adjustment of a lay brake with back disk brakes
      9.9.3. Lever replacement
      9.9.4. Replacement of cables
      9.9.5. Replacement of a brake liquid
      9.9.6. Prorolling of brake system
   # 9.10. Antiblocking system (ABS)
# 10. An electric equipment
# 11. A body
# 12. Electroschemes




9.9.2. Adjustment of a lay brake with back disk brakes
THE GENERAL DATA

Adjustment of a lay brake with back disk brake mechanisms

1 – an emphasis;

2 – the lever;

3 – a cable of a drive of a lay brake;

And – distance between the lever and an emphasis

PERFORMANCE ORDER
1. Remove the floor console.
2. Be convinced that the lever of a lay brake has been lowered against the stop downwards.
3. For self-installation of elements of a lay brake some times sharply press a brake pedal.
4. Tighten an adjusting nut 3 (fig. the Equalizer of cables of a drive of a lay brake see) until when levers 2 (see fig. Adjustment of a lay brake with back disk brake mechanisms) on brake mechanisms of back wheels will depart from an emphasis 1.
5. Measure distance and between the lever 2 and an emphasis 1 from both parties. It should not exceed 3 mm, and the sum of values and from both parties should be in limits of 1-4 mm.
6. For self-installation of elements of a lay brake three times tighten and lower the lever of a lay brake.
7. Lower the lever of a lay brake against the stop downwards and turn hands back wheels. They should rotate in regular intervals, without jammings.
8. Wheels should not be turned at a lever raising on five-seven clicks. Otherwise repeat adjustment.
9. Establish the floor console.